基于ARM芯片STR710的PDA硬件设计及液晶显示器驱动

JIMI

论文编号ZXX258  论文字数:10712,页数:29
摘  要：随着嵌入式设备与Internet或无线网络的广泛地结合，手机、PDA、路由器、调制解调器、远程控制器和智能家居等复杂的高端应用对嵌入式处理器的性能提出了更高的要求，因此开发32位高性能处理器将是嵌入式技术发展的必然趋势。本论文的设计主要采用ARM芯片设计一套简单的PDA系统，该系统可以用于其它的控制系统，为进一步的开发做准备。系统选用ST公司的ARM7芯片STR710来设计一套嵌入式的 PDA控制器。主要实现对外部设备的一些参数采集及控制功能，包括显示、数据处理及其他控制功能。本论文主要介绍了整个硬件电路及软件的设计。包括硬件原理图设计，整个ST软件平台启动程序的设计，以及LCD控制器和NANAD_FLASH的驱动程序的设计。
关键词：ARM系统； 嵌入式； 液晶显示器； 非线性闪存

Abstract:Along with the widely combination of embedded device and Internet or wireless network ,the complex application such as mobile phone, PDA, router ,  modem , long-distance controller and the intelligence home etc put forward higher demand on the performance of embedded processor, therefore developing 32-bit high performance processors will be an inevitable trend. The design of the present dissertation mainly uses the ARM chip to bring out a simple PDA system which can also be applied in other system, i.e.   this digital board also prepares for the further development. This system selects ST Corporation’s ARM7 chip STR710 to design an embedded PDA controller. It mainly implement on gathering some parameter and controlling external equipment, the function including display, data processing and other control process. The dissertation mainly introduced entire hardware electric circuit and software design, including schematic diagram design of digital board and start-up procedure design in software.
Keywordsd: ARM System; Embedded  System; LCD; NAND_FLASH